Applies to: An installed Century MidiaBox HDTV B7 in Brazil, showing a SAT HD Regional activation banner. Match the B7 label and the installed satellite system. A SKY/Nova Parabólica activation screen uses a different service; this guide does not change the dish, firmware or subscription.
Match your symptom
| What you see | What to do next |
|---|---|
| Activation banner with a picture | For SAT HD Regional, open Menu > Informações and inspect the activation QR destination, or start from Century’s official activation chooser. Keep SCUA and CAID private; copy the identifiers from your own receiver, and use its real installation state and city. Check the service name before submitting. A browser country selection on FixSatellite does not activate or regionalize a receiver. |
| No reception across channels | Read the existing signal-quality display without changing the LNBF configuration. The cited B7 manual requires at least 80% quality on channel 1 with the LNBF configured for SAT HD Regional activation. This is a B7-specific condition, not a universal meter threshold. If it is below that condition or fluctuates, ask an installer to assess reception rather than climbing to the dish. |
Work through these checks
Identify the service on screen
An installed Century MidiaBox HDTV B7 in Brazil, showing a SAT HD Regional activation banner. Match the B7 label and the installed satellite system. A SKY/Nova Parabólica activation screen uses a different service; this guide does not change the dish, firmware or subscription.
What the result means: An activation banner is not the same fault as a television reporting no HDMI signal. First check whether the B7 menus and an available free-to-air channel appear. If they do, note the blocked channel and banner before buying parts. If reception is missing across channels, activation cannot repair the installed feed.
Check the B7 reception condition
Read the existing signal-quality display without changing the LNBF configuration. The cited B7 manual requires at least 80% quality on channel 1 with the LNBF configured for SAT HD Regional activation. This is a B7-specific condition, not a universal meter threshold. If it is below that condition or fluctuates, ask an installer to assess reception rather than climbing to the dish.
What the result means: Do not factory-reset, erase the channel list, change satellites or install a firmware file merely to clear an activation banner. Stop for damaged wiring, heat, wet equipment or unsafe antenna access. Send device codes only to official private support; an activation form is not a reason to post them publicly.
Use private official activation
For SAT HD Regional, open Menu > Informações and inspect the activation QR destination, or start from Century’s official activation chooser. Keep SCUA and CAID private; copy the identifiers from your own receiver, and use its real installation state and city. Check the service name before submitting. A browser country selection on FixSatellite does not activate or regionalize a receiver.
What the result means: Save the official confirmation or error and any protocol privately. Century says a successful request can take a few minutes to reach the equipment; do not repeat registrations continuously. Regional channel availability is controlled by the broadcasters. A national feed where no regional feed is offered can be expected, rather than a faulty receiver. Ask Century if the request is accepted but the banner persists.
When to stop and get help
Do not factory-reset, erase the channel list, change satellites or install a firmware file merely to clear an activation banner. Stop for damaged wiring, heat, wet equipment or unsafe antenna access. Send device codes only to official private support; an activation form is not a reason to post them publicly.
What to tell support
Save the official confirmation or error and any protocol privately. Century says a successful request can take a few minutes to reach the equipment; do not repeat registrations continuously. Regional channel availability is controlled by the broadcasters. A national feed where no regional feed is offered can be expected, rather than a faulty receiver. Ask Century if the request is accepted but the banner persists.
Common questions
Can I change the registered city immediately?
Century’s cited SAT HD Regional instructions impose a 90-day interval before reactivation for another city/state. Ask official support about a move or an incorrect registration; do not invent a location or repeatedly submit it as a troubleshooting shortcut.
Original troubleshooting guidance based on the official sources below. Menu names can change. This is an independent guide, not a manufacturer service bulletin or a bench-tested repair.