Applies to: Emitor Satlook Micro G2 / HD · Updated September 20, 2010 · G2 firmware above smG2HD-106
Work through these checks
01 · Emitor Satlook Micro G2 / HD
Match the exact hardware, tuner standard and manual. Keep LNB feed and TV/AV display connections distinct. Preserve saved channel plans and transponders.
02 · DVB-S / DVB-S2 / smG2HD-106 / ONID/TSID / NIT
In this Micro G2/HD manual, G2 supports DVB-S while HD also supports DVB-S2. The G2 instructions apply only above firmware smG2HD-106. Record modulation and the four lock boxes using the correct model's table: their meanings differ. ONID/TSID and NIT may arrive later or be absent; a relayed transport stream may carry an incorrect orbital position. Missing DVB-S2 lock on G2 alone is not evidence of a defective feed.
03 · RF
Read level, quality or error measurements together with lock and the selected transponder. Compare only unchanged units and settings at the same measuring point. Wrong satellite data or an unsupported standard can make a working feed look faulty.
When to stop and get help
Stop for damaged cables, unexpected voltage or short-circuit warnings; ask a qualified installer or meter service. Do not bypass protection, change LNB power, DiSEqC/SCR, motor settings, calibration or firmware, or reset to test.
What to tell support
Save model, manual edition, software, measuring point, satellite/transponder, units and the original screen or error. Keep site identifiers private.
Original troubleshooting guidance based on the official sources below. Menu names can change. This is an independent guide, not a manufacturer service bulletin or a bench-tested repair.