Confirm your model
iDirect iQ Desktop+ Satellite Router · T0001107 Rev A; July 1, 2019. Match the exact model, product code and manual edition. Record the existing connections, status indicators and displayed error without changing them. Preserve settings and stored data; do not reset, flash software, format storage or alter wiring as a first check. Keep account details, device identifiers and precise location private.
How it connects
Identify iDirect iQ Desktop+ with the 52-page Installation, Support, and Maintenance Guide T0001107 Rev A, July 1, 2019; not iQ Desktop, iQ200 or another iQ model. One physical router, no software/component credits. LED meanings may vary by iDX release; match the installed release documentation, not the supplier folder name. Observe existing PWR/STAT/RX/TX/NET (printed 8–11). PWR green is power only; STAT half-second green flashing initializes, steady green completes initialization. RX steady amber means demodulator not locked; one-second amber flashing means demodulator locked but NCR not locked; steady green means both locked. TX steady amber is disabled, one-second amber flashing acquires upstream, steady green upstream acquired. NET one-second green flashing acquires the network, steady green network acquired, not guaranteed application internet. The over-current pattern is PWR steady green, STAT red flashing each second, RX/TX yellow flashing each second and NET off; BUC supply is off while LNB supply stays on. The source says this state can last five minutes or until intervention; do not induce it or intervene as a test. In Listening Mode, PWR/STAT/RX steady green with TX steady yellow and NET off still does not mean restored transmission/network (11). Stop and refer the observed pattern to the provider; arrange safe isolation before qualified cable inspection. TX feeds the BUC, RX receives from the LNB; UART's RJ45 is console, not Ethernet ETH1/ETH2 (10). Preserve wiring, options, IP/VLAN and RF settings. Level 0 reboots; Level 1 factory recovery has no in-place recovery and requires software/options/configuration reload (37–38); do not press reset or enter either mode. Do not commission/point, enable TX, issue commands, run traffic/tests/calls, change settings, reboot/update/reload or export/send reports. No live cable, opening, supply/voltage/fuse/battery work; do not interrupt a known update. Observe safe ventilation only; overheating can shut down the board (20), not permission to open or alter power. Protect IDs, IPs, positions and configuration. Supplier-hosted historical manufacturer original gives no current network, service, licensing or compatibility assurance.
Before buying parts
These are compatibility notes and official reference links. Confirm the fault and exact part before buying.
Model-specific parts: start with the official source
Confirm the exact model and part number with the manufacturer or provider before buying any replacement part or accessory.
Check the model and official instructions ↓