English
EnglishEspañolFrançaisالعربيةDeutschPortuguêsItalianoفارسیBahasa IndonesiaاردوTiếng ViệtBahasa MelayuRomânăΕλληνικάहिन्दीNederlandsTürkçePolskiไทยУкраїнськаРусскийČeština한국어বাংলা日本語简体中文繁體中文FilipinoKiswahiliSvenskaעבריתSuomiDanskMagyarNorsk bokmålதமிழ்

Your country is detected for each new visit. You can choose your country and language.

RV & marine / Detailed guide

Jotron Tron 40S MkII / Tron 40GPS MkII · Exact manual and safe first checks

Jotron Tron 40S MkII / Tron 40GPS MkII · 82819_UM_40SMkII_J · revision J record 12.07.11 (literal) · 36 pages

Applies to: Jotron Tron 40S MkII / Tron 40GPS MkII · 82819_UM_40SMkII_J · revision J record 12.07.11 (literal) · 36 pages

Work through these checks

  1. 01 · Jotron Tron 40S MkII / Tron 40GPS MkII

    This is only a passive troubleshooting review of existing records; it does not replace the manufacturer’s instructions for an actual distress situation. Match Tron 40S MkII / Tron 40GPS MkII to 82819_UM_40SMkII_J; J / 12.07.11 identifies the document record, not installed firmware. Read only an already recorded diagnostic sequence; do not start TEST or handle the beacon. Here one flash means no fault indicated by that past test. Two/four flashes indicate low 406/121.5 MHz output respectively; five/six indicate the corresponding PLL out of lock; seven means the module is unprogrammed or incompletely programmed. This does not establish current readiness, registration or rescue reliability. For troubleshooting only, do not activate, test, transmit, reprogram, open or remove it from its bracket. Do not publish identifiers or location in public troubleshooting posts; give the existing record to authorized service.

When to stop and get help

Do not continue these checks in unsafe conditions. For immediate danger, use local emergency services and the device’s emergency instructions. Otherwise, contact your provider or a qualified technician.

What to tell support

This is only a passive troubleshooting review of existing records; it does not replace the manufacturer’s instructions for an actual distress situation. Match Tron 40S MkII / Tron 40GPS MkII to 82819_UM_40SMkII_J; J / 12.07.11 identifies the document record, not installed firmware. Read only an already recorded diagnostic sequence; do not start TEST or handle the beacon. Here one flash means no fault indicated by that past test. Two/four flashes indicate low 406/121.5 MHz output respectively; five/six indicate the corresponding PLL out of lock; seven means the module is unprogrammed or incompletely programmed. This does not establish current readiness, registration or rescue reliability. For troubleshooting only, do not activate, test, transmit, reprogram, open or remove it from its bracket. Do not publish identifiers or location in public troubleshooting posts; give the existing record to authorized service.

Original troubleshooting guidance based on the official sources below. Menu names can change. This is an independent guide, not a manufacturer service bulletin or a bench-tested repair.