Applies to: Emitor DIGISAT PRO / PRO ACCU · Original Version 2.00 manuals; publication date not established
Work through these checks
01 · Emitor DIGISAT PRO / PRO ACCU
Match the exact hardware, tuner standard and manual. Keep LNB feed and TV/AV display connections distinct. Preserve saved channel plans and transponders.
02 · LNB1/LNB2 / Receiver Video / ATT / Motor control / DiSEqC Control
For DIGISAT PRO / PRO ACCU, match the original Version 2.00 manuals. With both LNB1/LNB2 graphs displayed, the meter alternates inputs and interrupts the video data passed to the receiver. Receiver Video needs one known LNB selected in Signal view; record single versus dual input first, without attaching new powered feeds. ATT indicates attenuation and T identifies the audible-tone input, not satellite lock. Do not enter Motor control or DiSEqC Control for this check.
03 · RF
Read level, quality or error measurements together with lock and the selected transponder. Compare only unchanged units and settings at the same measuring point. Wrong satellite data or an unsupported standard can make a working feed look faulty.
When to stop and get help
Stop for damaged cables, unexpected voltage or short-circuit warnings; ask a qualified installer or meter service. Do not bypass protection, change LNB power, DiSEqC/SCR, motor settings, calibration or firmware, or reset to test.
What to tell support
Save model, manual edition, software, measuring point, satellite/transponder, units and the original screen or error. Keep site identifiers private.
Original troubleshooting guidance based on the official sources below. Menu names can change. This is an independent guide, not a manufacturer service bulletin or a bench-tested repair.