Applies to: Emitor Combolook Color HD S2/T2/C · Updated September 5, 2012
Work through these checks
01 · Emitor Combolook Color HD S2/T2/C
Match the exact hardware, tuner standard and manual. Keep LNB feed and TV/AV display connections distinct. Preserve saved channel plans and transponders.
02 · Satellite-TV / Digital-TV / DVB-T/T2/C / MPEG4 / MPEG2
Match Combolook Color HD S2/T2/C to its September 2012 manual. Distinguish Satellite-TV from Digital-TV (DVB-T/T2/C) mode and record the existing input. The wrong mode is not proof of a bad LNB. A DVB-S2 lock does not establish MPEG4 picture decoding: this manual confirms MPEG2 free-to-air display on the built-in screen. Record modulation, SR, FEC, NIT and quality information when available rather than resetting or rescanning to solve a mode/display question.
03 · RF
Read level, quality or error measurements together with lock and the selected transponder. Compare only unchanged units and settings at the same measuring point. Wrong satellite data or an unsupported standard can make a working feed look faulty.
When to stop and get help
Stop for damaged cables, unexpected voltage or short-circuit warnings; ask a qualified installer or meter service. Do not bypass protection, change LNB power, DiSEqC/SCR, motor settings, calibration or firmware, or reset to test.
What to tell support
Save model, manual edition, software, measuring point, satellite/transponder, units and the original screen or error. Keep site identifiers private.
Original troubleshooting guidance based on the official sources below. Menu names can change. This is an independent guide, not a manufacturer service bulletin or a bench-tested repair.